Contact CNC Plasma Machines
Tell us what you need, whether that is a pre-owned plasma machine, a trade-in, spares from broken machines or a relocation job. The more detail you send through our contact form, the easier it is to match the right machine, part or site work.
Send us a message
Tell what you need, with the sizes, quantities or site details that matter to the job. Fields marked * are required.
Send the details that matter
If you are looking for a machine, tell us the cutting width and length you need, the material thickness you normally cut and the town where the machine will run. If you are asking about spares, include the part you need and clear photos of the item still fitted if possible.
- Machine type, table size and preferred cutting area in metres
- Material range, usual plate thickness and workshop power supply
- Your town, access constraints and whether offloading equipment is on site
- For spares, close photos of the damaged or missing part
Trade-ins and machines you want to sell
For trade-ins, give the make-free basics and keep the sales talk out. We need to know the bed size, controller condition, torch height control status, drive type and whether the machine is under power. A few honest photos saves time for everyone and helps us judge whether it suits resale, strip-down for parts, or a sold-as-seen listing.
- Overall photos from each side and one of the gantry
- Close photos of rails, slats, drives, control cabinet and torch assembly
- Any known faults, missing parts, crash damage or rust around the table
- Your area, loading method and whether a forklift is available
Relocation work across South Africa
We handle removals and recommissioning from Durban across KwaZulu-Natal and for workshop moves elsewhere in South Africa. Let us know the collection point, delivery point and whether the route includes narrow access, stairs, low doors or long internal carries. A rough floor sketch helps, even a hand drawing is fine.
- Collection town and delivery town
- Machine footprint, approximate mass and bed length
- Loading access, roller doors and vehicle restrictions
- Photos of both sites, especially entrances and the machine position
Durban collection and visits
Machines and parts are handled from our Durban base. If you want to collect, note whether you are sending your own vehicle or arranging a carrier, and include the vehicle type so collection can be planned properly. For machine viewing, say which stock page item you are asking about and add any cutting sample requirements you have.
We cover Durban, Pinetown, Pietermaritzburg, Richards Bay and Newcastle regularly, with relocation work to and from the rest of the country as needed. Send the information through our contact form and keep the photos sharp. That helps more than a long message.